Maintenance

OPERATIONAL INSTRUCTIONS

LOAD ADJUSTMENT

The resistance of the shocks can be adjusted by twisting the adjustment knob at the top of the shocks. There are settings from 1 to 12. Setting #1 will provide the lowest resistance. Setting #12 will provide the highest resistance.

CAUTION: The shocks get HOT after a few minutes of use.

Adjustment

Knob

Mark

The safety and integrity designed into the BODYTRACTM can only be maintained when the BODYTRACTM is regularly examined for damage and wear. Special attention should be given to the following:

1.Pull on the HANDLEBARS(17, 18) and verify that the SHOCK(22) provides tension.

2.Clean the roller tracks in the CENTER BEAM(1) with an absorbent cloth.

3.Verify that the WARNING LABEL(67) is in place and easy to read. Call Stamina Products immediately at 1-800-375-7520 for a replacement WARNING LABEL(67) if it is missing or damaged.

4.It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

5.Worn or damaged components shall be replaced immediately or the BODYTRACTM removed from service until repair is made.

6.Only Stamina Products supplied components shall be used to maintain/repair the BODYTRACTM.

7.Keep your BODYTRACTM clean by wiping it off with an absorbent cloth after use.