Stamina Products 35-1050C owner manual Remove the Locking KNOBS13 from the Pivot CONNECTOR10

Page 9

ASSEMBLY INSTRUCTIONS

STEP 4

Insert the PEDAL SHAFT(32) through holes located on the METER POST(31). Place a PEDAL SPACER(33) and a PEDAL(34) onto each end of the PEDAL SHAFT(32) and slide them toward the METER POST(31). Then secure the PEDALS(34) with BUTTON HEAD BOLTS(M8x1.25x15mm)(51) and LARGE WASHERS (M8)(36) at both ends of the PEDAL SHAFT(32).

NOTE: You need to use two Allen Wrenches to tighten the BUTTON HEAD BOLTS(M8x1.25x15mm)(51) at both ends of the PEDAL SHAFT(32) at the same time.

STEP 5

Remove the LOCKING KNOBS(13) from the PIVOT CONNECTOR(10).

9

Image 9

Contents Stamina Products This Product is Produced Exclusively byTable of Contents Safety Instructions800 Call US FirstBodytractm Before YOU BeginEquipment Warning & Notice Labels Part No. and Description Qty Hardware Identification ChartStep Assembly InstructionsConnect the Extension WIRE39 to the Sensor WIRE40 Remove the Locking KNOBS13 from the Pivot CONNECTOR10 Assembly Instructions Assembly Instructions HOW to Install and Replace Batteries Using the Fitness MeterOperational Instructions Function ButtonMaintenance Operational Instructions Load AdjustmentFolding the Bodytractm StorageTarget Heart Rate Zone Estimated by Age Conditioning GuidelinesDo not Bounce WARM-UP and COOL-DOWNWarranty Limited WarrantyBack Product Parts DrawingPart Name Parts ListPart Name QTY Page Stamina Products, Inc Box Springfield, MO FAX/MAIL Ordering Form