Stamina Products 35-1050C owner manual Operational Instructions, Function Button, Functions

Page 12

OPERATIONAL INSTRUCTIONS

USING THE FITNESS METER

Power on : Seat movement or push the button.

Power off : Automatic shut off after 4 minutes of inactivity.

Function Button:

MODE/RESET: Press and release to select functions. Press and hold for two seconds to reset all functions to zero, except TOTAL COUNT.

Functions:

SCAN: Automatically scans each function of TIME, TOTAL COUNT, COUNT, and CALORIES in sequence with a change every six seconds.

TIME: Displays the elapsed time, from 1 sec up to 99:59 minutes.

COUNT: Displays the total number of rows you have taken, from zero to 9999 rows.

TOTAL COUNT: Displays the total accumulated number of rows you have taken, from zero to 9999 rows. The total accumulated rows is retained when the meter is turned off.

CALORIES: Displays the calorie consumption, from zero to 9999 cal.

The calorie readout is an estimate for an average user. It should be used only as a comparison between workouts on this unit.

NOTE: 1. The meter will shut off automatically after 4 minutes of inactivity. All function values will be kept. Push the button and hold it down for two seconds to reset all functions to zero, except TOTAL COUNT.

2.The TOTAL COUNT will be reset to zero after batteries are removed for battery replacement or storage of the unit.

AA Batteries

HOW TO INSTALL AND REPLACE BATTERIES:

1. Open the Battery Door on the back of the meter.

2. The meter operates with two AA batteries, two batteries included. Refer to the illustration to install or replace the batteries.

NOTE:

1. Do not mix a new battery with an old battery.

2. Use the same type of battery. Do not mix an alkaline battery with another type of battery.

3. Rechargeable batteries are not recommended.

12

Image 12
Contents This Product is Produced Exclusively by Stamina ProductsSafety Instructions Table of ContentsCall US First 800Before YOU Begin BodytractmEquipment Warning & Notice Labels Hardware Identification Chart Part No. and Description QtyAssembly Instructions StepConnect the Extension WIRE39 to the Sensor WIRE40 Remove the Locking KNOBS13 from the Pivot CONNECTOR10 Assembly Instructions Assembly Instructions Using the Fitness Meter HOW to Install and Replace BatteriesOperational Instructions Function ButtonOperational Instructions Load Adjustment MaintenanceStorage Folding the BodytractmConditioning Guidelines Target Heart Rate Zone Estimated by AgeWARM-UP and COOL-DOWN Do not BounceLimited Warranty WarrantyProduct Parts Drawing BackParts List Part NamePart Name QTY Page FAX/MAIL Ordering Form Stamina Products, Inc Box Springfield, MO