Coleman 2000001088 manual Before you begin, Parts and Components, To Set Up Tent

THE SLEEPY OWLTM TENT 8’ X 7’

MODEL 2000001088

Before you begin

Read all instructions before set up.

•Select a level campsite clear of rocks, branches, and other hard or sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

•Do not set up your tent under trees.

•For best results in windy conditions, position end of tent into the wind.

•Enlist the help of at least one other person to assist you when it is time to assemble the tent.

Parts and Components

Description	Part Number
Main Pole, Black (1)	5010000372
Side Poles, Gray (2)	5010000370
Rainfly	5010000371

STITCH LINE

To Set Up Tent

1.Unfold tent and spread out on a clean, level surface with the door facing the desired direction. (Fig. 1)

2.Assemble black main tent pole and both gray side poles by interlocking, shock-corded, sections.

3.Insert main pole through center sleeve (trimmed in black); then insert the two side poles through the outer sleeves (trimmed in gray) as shown. (Fig. 1)

Black, Shock-corded

Main Pole

Sleeve with Gray Trim

Sleeve with Black Trim

Gray, Shock-corded	Door
Side Poles		Sleeve with Gray Trim

Fig. 1

4.Insert one end of main pole into center pin on side of tent; then the gray side poles into the other remaining side pins (Fig. 2, 2A, & 2B). NOTE: The side poles should be on top of the black main pole.

5.Go to opposite end of each pole and gradually apply pressure to the pole forming an arch. Insert the pins into the poles end at the other side of tent. The side poles will form an “X” on top of the black main pole when properly installed. (Fig. 2, 2A, & 2B)

6.Wrap the strap, on each side of the tent, around the three poles & secure by placing toggle through loop in strap. (Fig. 2B & 2C)

7.Stretch web straps at corners and loops on sides of tent until floor is taut; then hammer stakes through loops to secure. (Fig. 2D)

2C

2D

Strap &

Toggle

Door

2B

2A

Fig. 2

(continued on other side)