under the patient's buttock area; your fingers should just
fit. If the | fit is too loose, decrease the setting. If your fingers |
do not fit | well, increase the setting two notches firmer. Wait |
ten minutes and then check again. You should only have to adjust this setting one time per patient. Please consult your physician for an appropriate setting.
QUICK DISCONNECT
Pull the power plug from the wall connector to disconnect the device quickly.
TRANSPORT CAP
In case of power failure or transport: Disconnect the quick connector and cap the mattress with the transport cap to slow deflation.
CPR FUNCTION
If CPR must be performed on the patient while the mattress is in use, to immediately deflate the mattress, either:
1.Pull the CPR valves from the mattress in the location of the arrow shown at right, or
2.Disconnect the quick connector from the pump in the location of the arrow shown at right.
quick connector
transport cap
| 15 |