General Preparation
| Note |
|
|
|
|
|
|
| |
In this manual,Base Modelmeans the | SelectaDock |
| ||
Base Model I,SelectaDockmeans the | SelectaDock | II, | ||
and SelectaDock Docking Systmemans | the Base |
| ||
Model and SelectaDock when docked together | as one | |||
unit. |
|
| ||
|
|
|
|
|
1.The SelectaDock supports the ThinkPad 760E, 760ED, and 760ELD. When any other model is
docked to the SelectaDock, a beep sounds. Check which model of the ThinkPad is docked to the SelectaDock before maintenance.
2. Verify | the Base Model is correctly docked (connected) |
to the | SelectaDock. |
3.Verify the computer is correctly docked (connected) to the SelectaDock Docking System.
4.Dock a
verify proper operation. If there is a problem, replace the Base Model.
5.If possible, make sure there are no hardware setting conflicts, such as in interrupt levels, memory
addresses, DMA channels, and I/O addresses.
6. | If | the | PCI | or | the | ISA card is installed, verify the card |
| is | supported | by | the | computer. | |
7. | Verify | the | SCSI | ID | is set correctly. | |
8.Test and correct any computer problems before you test it with the SelectaDock Docking System. Use the computer documentation to resolve any computer problems.
9.Test the computer with the external keyboard, external display, mouse, and parallel and serial device connectors. (Use the keyboard/mouse
connector to test the external keyboard | and mouse.) |
If no problems are found, connect the | external |
keyboard, mouse, parallel and serial devices to the SelectaDock Docking System. Then connect the SelectaDock Docking System to the computer and
test it.
10.If external devices are attached to the SelectaDock Docking System, such as an audio amplifier, check
the device by referring to the manual shipped with it.
11.If the user did not bring the computer with a SelectaDock Docking System when service is
needed, use a computer that works correctly with the SelectaDock Docking System.
3