IBM S84H-4552-00 manual Printer, External Display

System (except the SCSI hard disk). The FDD-2 or PCMCIA-2 icons represent the FDD or PCMCIA attached through a port replicator or in the SelectaDock Docking System.

Printer

Test the printer by connecting it to the computer before testing it on the SelectaDock Docking System.

1.Make sure the printer is correctly connected and is powered on.

2.Run the printer self-test.

If	the	printer	self-test	does	not run correctly, the problem is
in the printer. Refer to				the	printer	service manual.
If	the	printer	self-test	runs	correctly, connect a wrap plug
on the parallel connector on the					rear	of SelectaDock
Docking System and run the advanced diagnostic tests to
determine		the failing FRU.

If the advanced diagnostic tests (with the wrap plug connected) did not detect a failure, replace the printer cable.

If the problem is not corrected, do one of the following:

ŸIf the printer is attached to the parallel connector of

SelectaDock

Docking System,

replace

the

main card

of

SelectaDock

Docking

System.

Ÿ If

the printer is attached to

the

parallel

connector on

the

adapter,

replace

the FRUs

in

the

following order

one

at a

time

until

the

problem

is

corrected:

Note

If the

replaced

FRUs

do not

resolve

the

problem,

put the original FRUs back in

the

SelectaDock

Docking System. Do not replace nondefective

FRUs.

1.Adapter

2.Main card of SelectaDock Docking System

External Display

If	the	screen		is	rolling, replace			the	external		display.
If the problem is not corrected, replace FRUs in the
following		order		one	at a	time	until	the	problem		is corrected:
	Note
If	the		replaced		FRUs	do	not resolve			the problem, put
the original FRUs back in the SelectaDock										Docking
System. Do			not	replace		nondefective		FRUs.

ŸIf the external display is attached to the SelectaDock Docking System:

1.Main card of SelectaDock Docking System

9