STEP 6
C
B 
E
Cable #1
6a
D
A
6b
YELLOW BAG
Wrap one end of cable #1 around pulley A. On the right side of the unit, place it through pulleys B, C, D of 6a, and E. Remove the nuts from 2 slotted bolts (M12) (see diagram below). With the threads pointing down on the slotted bolt (M12), slide the end of cable #1 through it. Reattach the nuts on the slotted bolt. Attach it to one side of the rear termination bracket (6b) with a 19mm wrench. Repeat on the left side. Thread each bolt attached to 6b evenly, on each side. The slotted bolt must have a minimum of 0.5” of thread engagement in the rear termination bracket (6b). Insert the weight selector pin (6c) anywhere in the weight stack. Finish by tightening down the upper locking nut to the bolt head on each side and the lower locking nut against the surface of 6b. Failure to do so may result in improper machine function or serious injury!
6c
14