STEP 1 ORANGE BAG
• Lay the back side of the rear vertical upright (1a) down onto the floor. The threaded bolt ends will be pointing up. Place the center floor support (1b) over the threaded ends. Attach a flat (10.5x18x2T) and spring (SW10.2x18.4x2.5T) washer and nut (M10x1.5P) to each end. Tip upright. Tighten fasteners using a 17mm wrench and a 6mm
• Slide the right floor support (1c) up to the rear vertical support and attach with two bolts (M10x1.5Px60L), two flat (10.5x30x2T) washers (outside of tube), two flat (10.5x18x2T) washers, and two nuts (M10x1.5P). Repeat the process with the left floor support (1d). Tighten with a 17mm wrench and a 6mm
1d
1a
| 1b |
1e | 1c |
|
9