5. Install the Handlebar
NXT Only
Positioning the handlebar post with the number 1 on top and insert the handlebar into the handlebar sleeve locking it at number 4.
Slide the handlebar onto the handlebar post insert with the water bottle holders facing forward and align the three screw holes.
Insert the socket head set screw into the handlebar but do not tighten at this time.
Insert the 2 flat head screws into the handlebar but do not tighten at this time.
Check for proper alignment then tighten the 2 flat head screws using a 5mm hex wrench to 60 inch pounds.
Tighten the set screw to 60 inch pounds using a 4mm hex wrench.
Slide the handlebar post into the frame making sure the holes face the front of the bike.
Allow the post to go into the frame all the way in to level 1 and align the pop pin so it snaps into the hole then tighten the pop pin and test for steadiness.
Loosen the pop pin and raise the handlebar to its highest position number 10 and tighten the pop pin and test for steadiness.
Pro & Elite Only
Slide the handlebar post into the frame making sure the holes face the front of the bike.
Allow the post to go into the frame all the way in to level 1 and align the pop pin so it snaps into the hole then tighten the pop pin and test for steadiness.
Loosen the pop pin and raise the handlebar to its highest position and tighten the pop pin and test for steadiness.
6.Install the Bottle Holders (Pro Only)
Using the 3mm Allen Wrench, remove the two screws from the right side fork of the frame assembly. Position a water bottle holder in place against the frame assembly, and
Repeat to install the cross member water bottle holder.
Step 5 (NXT)
Step 5 (Pro/Elite)
Step 6
Page 11 | STAR TRAC GROUP CYCLES OWNER’S GUIDE |