Star Trac V-bike Spinner Spinner Pro Spinner Elite Spinner NXT Moving and Leveling, Maintenance

MAINTENANCE _

This section provides the procedures to maintain the group cycles in serviceable condition. Differences between models are noted where applicable.

MOVING AND LEVELING

To move the cycle to a new location:

Lift the cycle from the rear and use the front wheels (located on the front leg, below the handlebar) to roll the cycle from one location to another.

To level the cycle:

Use the four leveling adjusters (located on the underside of the front and rear legs) to compensate for uneven floor surfaces.

PREVENTIVE MAINTENANCE

Perform regular scheduled preventive maintenance procedures to maintain your group cycle in serviceable condition.

TOOLS

Tools required for service and maintenance of your group cycle are listed below.

Tool	Purpose
Pedal Wrench, 15mm*	Remove and install pedals.
Shimano-compatible Bottom Bracket Tool*	Remove, install and adjust the bottom bracket. (V-bike only)
Cotterless Crank Puller*	Remove crank.
Metric Allen Wrench Set and Metric Socket, 2mm ~ 6mm	Install and adjust leg bolts, chain tensioner, brake pad and crank bolts.
Crescent (adjustable) Wrench	Adjust chain tension.
Torque Wrench	Adjust crank arm.
* Available at local bike or fitness-related stores.

DAILY MAINTENANCE

The service life of your group cycle will be determined by how consistently you perform the daily maintenance procedures. Dry the group cycle after each use to remove sweat and moisture. It is best to use a liquid non-abrasive cleaner and water solution.

Wipe Down / Cleaning

To prevent the build-up of rust and other forms of corrosion, wipe down the cycle at the end of each day (or preferably at the end of each class). Raise all posts to the highest setting to expose moisture. Using an absorbent cloth, focus on all areas that perspiration can settle. Give particular attention to the following areas:

oHandlebar

oSeat / adjustable slide for the seat o Flywheel

o Back leg assembly o Chain guard

o Brake knob and bolt assembly o Pop-pins

o Leveling feet

NOTE: Never use abrasive cleaning liquids or petroleum-based solvents when wiping down the cycle.

NOTE: It is recommended that class instructors direct class participants to release all the tension from the cycle at the end of each class to allow perspiration to evaporate.

Page 16 STAR TRAC GROUP CYCLES OWNER’S GUIDE