Star Trac V-bike Spinner Spinner Pro Spinner Elite Spinner NXT manual Inspection / Adjustment

Inspection / Adjustment

Inspect major moving parts that require constant proper torque. Loose or misadjusted parts can result in personal injury or damage to the cycle. Check the following parts for security and/or proper torque.

Crank arms

Use a foot pound torque wrench, tighten to 30 - 35 foot-pounds.

Pedals

Use a pedal wrench. Verify that the pedal is not cross-threaded.

IMPORTANT: If your facility allows members to interchange pedals, it is critical that the pedals are checked after each class to prevent damage, which may lead to injuries if ignored.

Water bottle (V-bike & Spinner Pro)

Tighten down assembly screws.

NOTE: Water bottle cages are easily damaged when oversized bottles are forced to fit within the bottle cage. Checking and tightening the screws will help prevent damage.

WEEKLY MAINTENANCE

Weekly maintenance should focus on the overall performance of the group cycle. During these inspections, look for vibration and possible loose assemblies.

Have an experienced rider ride each cycle to identify and help diagnose any vibration, noises, and any "unusual" feeling from the drive chain. Either faulty flywheel alignment or a loose chain can cause vibration.

oCheck for proper flywheel alignment. Torque flywheel nuts as necessary.

oRemove chain guard and check for loose chain. Adjust chain as necessary (refer to "Chain Adjustment" on page 14).

oInspect The Bottom Bracket Assembly (BBA). The BBA will come loose periodically and require tightening. Loose play (left and right motion) indicates the BBA needs adjusting. (V-bike only)

Inspect each cycle for loose assemblies, parts, bolts and nuts. Give particular attention to the following:

oTighten all frame base hardware. o Tighten all pull pin handles.

o Tighten seat hardware.

o Tighten pedal toe clip / toe straps.

o Inspect and tighten tension knob assembly.

MONTHLY MAINTENANCE

The monthly maintenance check should be a comprehensive inspection of the overall frame and main assembly components of the group cycle.

Inspection

Inspect the frame and main assembly components for rust or corrosion. Tilt the cycle or place in an upside down position to locate areas where rust and corrosion may develop. Use a small, wire brush to remove rust build-up in small crevasses, such as leveling feet, pop pin handles and other bolt assemblies. Give particular attention to the following areas:

oLeveling feet o Pop pin handles

Inspect all wear items for adjustments or possible part replacement. Give particular attention to the following:

oInspect brake pad for wear. Excessive wear, such as glazing or leather separation, indicates replacement is required. o Inspect seat pad for wear. Rips, tears or excessive movement indicates replacement is required.

o Inspect pedals for play. Excessive movement of pedals indicates replacement is required.

Page 17 STAR TRAC GROUP CYCLES OWNER’S GUIDE