ASSEMBLY
1. Install the Back Leg
Place the back leg in position at the rear of the cycle, aligning the two holes in the leg with the mating holes in the frame bracket.
Insert two 8mm x 70mm bolts through the frame bracket and back leg, and install a flat washer and nut on each bolt. Using the #5 Allen Wrench and
Step 1
2. Installing the Front Leg
Place the front leg in position at the front of the cycle, with the casters facing forward, aligning the two holes in
the leg with the mating holes in the frame bracket.
Insert the two 8mm x 60mm bolts |
|
through the frame bracket and front |
|
leg, and install a flat washer and nut |
|
on each bolt. Using the #5 Allen |
|
Wrench and | Step 2 |
tighten the nuts securely. | |
3. Install the Pedals |
|
Install the pedals on the pedal cranks |
|
using the |
|
closed end of the pedal cage must point |
|
forward, toward the front of the cycle. |
|
NOTE: Turn the left pedal spindle |
|
counterclockwise when threading into |
|
the crank arm; turn the right pedal |
|
spindle clockwise when threading into |
|
the crank arm. |
|
| Step 3 |
4. Install the Seat |
|
Insert the seat post into the frame |
|
assembly and secure in place using a |
|
tension handle. |
|
Position the seat on top of the seat post |
|
and secure in place using a tension |
|
handle and washer. |
|
NOTE: Tighten the tension handles |
|
firmly. |
|
| Step 4 |
Page 5 | STAR TRAC GROUP CYCLES OWNER’S GUIDE |