3. Place Computer into Shoe
Place the computer into the mounting shoe on the handlebar or stem. Line up the slots on the base of the computer with the bracket and slide computer toward the rider (FIGURE 5). NOTE: Ensure the computer is fully inserted onto the receiver shoe for proper data transmission.
4 Heart Rate Monitor Strap |
| |
Position the heart rate monitor strap on your torso as pictured in FIG- | FIGURE 6 | |
URE 6. The strap should rest just beneath the pectoralis muscles of | ||
| ||
the chest. For best results slightly moisten the electrodes where con- |
| |
tact is made with skin. The heart rate strap must be worn to enable |
| |
the heart rate function. NOTE: The chest strap for the PowerTap SL2.4 |
| |
uses a coded frequency and is not compatible with other manufactur- |
| |
er’s chest straps. |
| |
|
| |
5. Verify Installation | FIGURE 7 | |
Check to make sure all components are properly secured. Spin the |
| |
rear wheel and verify that in the upper left hand corner of the com- |
| |
puter the transmission icon illuminates (FIGURE 7). This indicates |
| |
the hub is properly transmitting a signal to the receiver and com- |
| |
puter. If the transmission icon is not illuminated consult Finding |
| |
Section Sensors for further instructions. |
|
10