Assembly
5.Connect the console harness together. One side of harness is coming from the left upright. The other end is coming from the console.
Attach the console onto the uprights by sliding into the uprights.
NOTE: Make sure that the console har- ness is inside of the upright and not being pinched.
Secure the console to the uprights using two bolts M10x25 and two washers M10 per side.
IMPORTANT PLEASE NOTE:
Tighten all hardware installed in Step 2 through Step 5.
Console |
Washer M10 |
Console |
Harness |
Bolt M10x25 |
Figure 5: Securing Console Assembly to Uprights
6.Locate the left and right covers. Secure the covers to the console using three screws on each side.
NOTE: Make sure not to pinch the wires when securing the covers.
Screw ST4.2x12 | Console |
| |
Left Cover |
|
Right Cover