Image IMTL19905 user manual Operation and Adjustment, PRE-LUBRICATED Walking Belt

Page 11

OPERATION AND ADJUSTMENT

THE PRE-LUBRICATED WALKING BELT

Your treadmill features a walking belt coated with high- performance lubricant. IMPORTANT: Never apply sil- icone spray or other substances to the walking belt or the walking platform. Such substances will deteriorate the walking belt and cause excessive wear.

HOW TO PLUG IN THE POWER CORD

DANGER: Improper connection of the equipment-grounding conductor can result in an increased risk of electric shock. Check with a qualified electrician or service- man if you are in doubt as to whether the

tric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug. Plug the power cord into a surge suppressor, and plug the surge suppressor into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Important: The treadmill is not compatible with GFCI-equipped outlets.

This product is for use on a nominal 120-volt circuit, and has a grounding plug that looks like the plug illus- trated in drawing 1 below. A temporary adapter that looks like the adapter illustrated in drawing 2 may be used to connect the surge suppressor to a 2-pole receptacle as shown in drawing 2 if a properly grounded outlet is not available.

product is properly grounded. Do not modify the plug provided with the product—if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

Your treadmill, like any other type of sophisticated electronic equipment, can be seriously damaged by sudden voltage changes in your home’s power. Voltage surges, spikes, and noise interference can result from weather conditions or from other appliances being turned on or off. To decrease the possibility of your treadmill being damaged, always use a surge suppressor with your treadmill (see drawing 1 at the right). To purchase a surge suppressor, see your local NordicTrack dealer or call the toll-free telephone number on the front cover of this man- ual and order part number 146148, or see your local electronics store.

1

2

Grounded Outlet Box Surge Suppressor

Grounding Pin

Grounding Pin

Grounded Outlet

Grounding Plug

 

Grounded Outlet Box

Adapter

Surge Suppressor

Use only a single-outlet surge suppressor that is UL 1449 listed as a transient voltage surge sup- pressor (TVSS). The surge suppressor must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must be electrically rated for 120 volts AC and 15 amps. There must be a moni- toring light on the surge suppressor to indicate whether it is functioning properly. Failure to use a properly functioning surge suppressor could result in damage to the control system of the treadmill. If the control system is damaged, the walking belt may change speed, accelerate, or stop unexpect- edly, which may result in a fall and serious injury.

This product must be grounded. If it should malfunc- tion or break down, grounding provides a path of least resistance for electric current to reduce the risk of elec-

Lug

Metal Screw

The temporary adapter should be used only until a properly grounded outlet (drawing 1) can be installed by a qualified electrician.

The green-colored rigid ear, lug, or the like extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adapter is used it must be held in place by a metal screw. Some 2-pole receptacle outlet box covers are not grounded. Contact a qualified elec- trician to determine if the outlet box cover is grounded before using an adapter.

11

Image 11
Contents Mon.-Fri., 6 a.m.-6 p.m. MST QUESTIONS?Model No. IMTL19905.0 Serial No Call TOLL-FREETable of Contents Treadmill Operation Important PrecautionsPage Power Lines Before YOU Begin Assembly Upright 111 make sure that the top of the Long One connector and try againWashers 114. Firmly tighten the four Console Bolts This stepPage Is facing the Console Back. Attach the receiver to Make sure that no wires are pinched. ReattachCeiver so the small cylinder is oriented as shown PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerChange the incline of the treadmill as desired Adjust the cushioning system as desiredTurn on the fans if desired Measure your heart rate if desiredIdentify yourself as user A, B, C, or D HOW to USE a Preset ProgramSelect one of the preset programs Adjust the intensity level of the program if DesiredSelect one of the custom programs HOW to Create a Custom ProgramHOW to USE a Custom Program Select a pulse program HOW to USE a Pulse ProgramEnter a maximum target heart rate setting Adjust the cushioning system as desired Audio Cable HOW to Connect Your MP3 Player or CD PlayerHOW to Connect Your Portable Stereo HOW to Connect Your Computer HOW to Connect Your Home StereoPress the Play button on your MP3 player, CD Player, or VCR HOW to Connect Your VCRMeasure your heart rate if desired Return to the treadmill and stand on the foot Directly from OUR WEB SiteFollow the on-line instructions to start Program HOW to Connect a Catv Cable HOW to Operate the Personal TelevisionDiagram of the Television Controls HOW to Connect AN AntennaBasic Television Operation HOW to Connect a VCRPress the Power button to turn on Television Press the Volume buttons to adjust the volumePress the Stop button again and add or delete Channels HOW to USE the Remote ControlHOW to USE the Information Mode Information mode HOW to Move the TreadmillPress the Stop button again and restore Console to the factory settings if desiredTop TroubleshootingProblem The power turns off during use Problem Television reception is poor Problem The walking belt slows when walked onProblem The remote control does not function properly Exercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesQty Description R1005AQty Exploded DRAWING-Model No. IMTL19905.0 Exploded DRAWING-Model No. IMTL19905.0 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty