Image IMTL19905 user manual Problem The walking belt slows when walked on

Page 31

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 11.

b. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 3 to 4 inches off the walking platform. Be careful to keep the walk- ing belt centered. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b

3”–4”

 

 

Rear Roller Bolts

c. If the walking belt still slows when walked on, see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the allen wrench to turn the left rear roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left rear roller bolt counterclockwise 1/2 of a turn. Be care- ful not to overtighten the walking belt. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.

a

b. If the walking belt slips when walked on, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is correctly tight- ened, you should be able to lift each edge of the walk- ing belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b

PROBLEM: Television reception is poor

SOLUTION: a. For the television to operate properly, good reception is necessary. If you are using an antenna, make sure that it is properly connected and adjusted for optimal reception. (See HOW TO CON- NECT AN ANTENNA on page 26.)

b. Check for the problems listed below and follow the applicable instructions.

Ignition (black spots or horizontal streaks that appear or a picture that flutters or drifts)—Usually this is caused by interference from automobile ignition systems, neon lamps, electric drifts, or other electric appliances. Try changing the position of the treadmill or other electric appliances to correct the problem.

Ghosts—Ghosts are caused by the television signal following two paths—one is the direct path and the other is reflected from tall buildings, hills, or other objects. Change the direction or posi- tion of the antenna to improve reception.

31

Image 31
Contents Mon.-Fri., 6 a.m.-6 p.m. MST QUESTIONS?Model No. IMTL19905.0 Serial No Call TOLL-FREETable of Contents Treadmill Operation Important PrecautionsPage Power Lines Before YOU Begin Assembly Upright 111 make sure that the top of the Long One connector and try againWashers 114. Firmly tighten the four Console Bolts This stepPage Ceiver so the small cylinder is oriented as shown Make sure that no wires are pinched. ReattachIs facing the Console Back. Attach the receiver to HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerChange the incline of the treadmill as desired Adjust the cushioning system as desiredTurn on the fans if desired Measure your heart rate if desiredIdentify yourself as user A, B, C, or D HOW to USE a Preset ProgramSelect one of the preset programs Adjust the intensity level of the program if DesiredSelect one of the custom programs HOW to Create a Custom ProgramHOW to USE a Custom Program Enter a maximum target heart rate setting HOW to USE a Pulse ProgramSelect a pulse program Adjust the cushioning system as desired HOW to Connect Your Portable Stereo HOW to Connect Your MP3 Player or CD PlayerAudio Cable HOW to Connect Your Computer HOW to Connect Your Home StereoPress the Play button on your MP3 player, CD Player, or VCR HOW to Connect Your VCRMeasure your heart rate if desired Follow the on-line instructions to start Program Directly from OUR WEB SiteReturn to the treadmill and stand on the foot HOW to Connect a Catv Cable HOW to Operate the Personal TelevisionDiagram of the Television Controls HOW to Connect AN AntennaBasic Television Operation HOW to Connect a VCRPress the Power button to turn on Television Press the Volume buttons to adjust the volumeHOW to USE the Information Mode HOW to USE the Remote ControlPress the Stop button again and add or delete Channels Information mode HOW to Move the TreadmillPress the Stop button again and restore Console to the factory settings if desiredProblem The power turns off during use TroubleshootingTop Problem Television reception is poor Problem The walking belt slows when walked onProblem The remote control does not function properly Exercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesQty Description R1005AQty Exploded DRAWING-Model No. IMTL19905.0 Exploded DRAWING-Model No. IMTL19905.0 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT