JVC FS-X5 manual Setting the on time Example AM, Setting the OFF time Example PM

Page 25

 

Using the Timers

On the Remote Control

2. Press the 3 or 2 button to set the minute, then press

 

the SET button.

English

1 Press the CLOCK/TIMER button repeat- edly until “ON (time)” appears on the display.

At this time, “DAILY” indicator blinks on the display. Each time you press the button, the display changes as follows.

DAILY ON?/DAILY OFF? = ON (time)* = Clock setting display = Cancelled = (back to the beginning)

*: Select this item!

The System enters ON-time setting mode, and the cur- rent ON time appears on the display and the hour digits blink.

2 Setting the ON time (Example: AM 10:15).

1.Press the 3 or 2 button to set the hour you want the System to come on, then press the SET button.

The minute digits of the ON time blink on the display. Pressing the 3 button moves the time forwards and pressing the 2 button moves it backwards.

Holding down the button moves the time.

2.Press the 3 or 2 button to set the minute, then press the SET button.

The System enters OFF-time setting mode, and the hour digits blink.

3 Setting the OFF time (Example: PM 1:30).

Note that the same time as the ON time cannot be set.

1.Press the 3 or 2 button to set the hour you want the System to be turned off, then press the SET button. The minute digits of the OFF time blink on the dis- play.

The System enter Music Source Selecting mode and “FM?” appears on the display.

4 Selecting the music source.

Press the 3 or 2 button to select the music source you want to listen to, then press the SET button.

Each time you press the 3 or 2 button, the display changes as shown below:

FM? ÔAM? ÔCD? ÔLINE?* Ô MELODY?

Ô(back to the beginning)

*: If the name has been changed, that name (e.g. “TAPE”) will appear. (See page 17.)

According to the music source you have selected, the next operation differs.

FM?

: Tunes in to the specified preset FM sta-

 

tion.

AM?

: Tunes in to the specified preset AM sta-

 

tion.

CD?

: Plays the specified track on the speci-

 

fied CD.

LINE?

: Plays an external source.

MELODY? : Select one of 10 melodies.

Preparation for each music source:

Perform the following operation according to the music source you have selected. Then, the System enters Vol- ume Setting mode.

●When selecting “FM?” or “AM?”

Press the 3 or 2 button to select the preset station number, then press the SET button.

•If you select the display “- -”, the current broad- cast station is selected.

●When selecting “CD?”

Press the 3 or 2 button to select the track number you want to start playback, then press the SET button.

•If you select the display “- -”, playback will start from the first track.

●When selecting “LINE?”

Prepare the external equipment so that it will turn on at the ON time set by the System.

To allow this, the equipment should have the timer function.

●When selecting “MELODY?”

Press the 3 or 2 button to select one of melodies (MELODY 1-10). Then, the selected melody is played back.

21

Page 24 Page 26
Image 25
Page 24 Page 26
Contents FS-X5 For U.S.A Mises en garde, précautions et indications diversesFor Canada/pour le Canada Disconnect the main plug to shut the power off completelyFront view Face Table of Contents Introduction FeaturesHow This Manual Is Organized How To Put Batteries In the Remote Control AccessoriesUsing the Remote Control Getting StartedUsing the Supplied Wire Antenna Connecting the FM AntennaUsing the Coaxial Type Connector Not Supplied Connecting the AM Antenna Connecting the Speakers SP-FSX5 Connecting an MD Recorder, etc Optical Digital Output Connecting an External EquipmentAutomatic Power On Basic Operations Turning the Power On and OffChanging the Source Power Saving Mode Dimmer at Power Off Adjusting the Brightness Dimmer at Power OnAdjusting the Volume Fade-out Muting Fade MutingTo disable the A.P.off function No signal conditionAuto Power Off A.P.off Entering the Number with the Remote Control Numeric KeysTuning In a Station Using the TunerSelect a station using one of the follow- ing methods One Touch RadioTo Change the FM Reception Mode Presetting StationsTo change the preset stations, repeat the same Beat Cut AM ReceptionWhen playing a CD-R or CD-RW Using the CD PlayerTo Insert a CD ControlTo Unload a CD Basics of Using the CD Player Normal PlayProgramming the Playing Order of the Tracks Program Play To Modify the Program Press the CD 6button on the Remote ControlRandom Play Repeat to program the other tracksLocking the CD door Repeating TracksUnlocking the CD door Turn off the systemListening to External Equipment Using External EquipmentsChanging the Equipment’s Name To exit the source LINE, select other source e.g. CDRecording the System’s Source to External Equipment Adjusting the Input LevelSetting the Clock Using the TimersPress the CLOCK/TIMER button Press the 3 or 2 button to set the hourPerform steps 2 to 5 in Setting the Clo- ck on Setting the Daily TimerShowing the Clock Display Correcting the ClockSetting the OFF time Example PM Setting the on time Example AMSelecting the music source Setting the volume level Turning the Daily Timer On and OffPress the Cancel button Select the Fade functionTimer Priority Setting the Sleep TimerDuring playback a source, press the Sleep button Wait for a few secondsSymptom TroubleshootingPossible Cause ActionCare And Maintenance Specifications Caractéristiques
Top Page Image Contents