JVC FS-SD990, FS-SD550 manual For U.S.A, Class 1 Laser Product

Page 2

Warnings, Cautions and Others

CAUTION

RISK OF ELECTRIC

SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK)

NO USER SERVICEABLE PARTS INSIDE

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclo- sure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral tri- angle is intended to alert the user to the pres- ence of important operating and maintenance (servicing) instructions in the literature accom- panying the appliance.

For U.S.A

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep- tion, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

–Consult the dealer or an experienced radio/TV technician for help.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

IMPORTANT FOR LASER PRODUCTS

REPRODUCTION OF LABELS

1. CLASSIFICATION LABEL, PLACED ON EXTERIOR SURFACE

CLASS 1

LASER PRODUCT

2. WARNING LABEL, PLACED INSIDE THE UNIT

1.CLASS 1 LASER PRODUCT

2.DANGER: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

3.CAUTION: Do not open the top cover. There are no user ser- viceable parts inside the unit; leave all servicing to qualitied service personnel.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

CAUTION

About the Internal Cooling Fan

This unit includes an internal cooling fan, so as to allow for high-power operation within a small space.

This fan comes on when the sound level is set high, and may also come on even at low sound levels if the internal temper- ature rises. To ensure effective fan operation, please leave at least 15cm clearance between the rear of the unit and the wall, and at least 1cm clearance on each side of the unit.

Caution — POWER switch!

Disconnect the mains plug to shut the power off completely. The POWER switch in any position does not disconnect the mains line. The power can be remote controlled.

G-1

Image 2
Contents FS-SD550/FS-SD770/FS-SD990 For U.S.A Class 1 Laser ProductIntroduction FeaturesInstallation of the System How This Manual Is OrganizedTable of Contents Using the Remote Control AccessoriesHow To Put Batteries In the Remote Control Getting StartedUsing the Coaxial Type Connector Not Supplied Connecting the FM AntennaUsing the Supplied Wire Antenna Rear Panel of the UnitConnecting the AM Antenna AM loop antenna SuppliedWhen attaching the speaker grille Connecting the SpeakersWhen removing Removing the speaker grillesConnecting an MD Recorder, etc Digital Output Connecting a SubwooferConnecting External Equipment On the Remote Control Connecting the AC Power CordAutomatic Power On Compu PlayAdjusting the Volume Turning the Power On and OffAdjusting the Brightness Dimmer Basic OperationsReinforcing the Bass Sound AHB PRO Fade-out Muting Fade MutingShowing the Time CLOCK/DISPLAY Tone Control BASS/TREBLESelect a station using one of the follow- ing methods Using the TunerTuning In a Station One Touch RadioManual Presetting Presetting StationsAuto Presetting To Change the FM Reception ModeTo Insert a CD Using the CD PlayerWhen playing a CD-R or CD-RW Quickest Way To Start a CD Is With the One Touch OperationTo Play a CD Basics of Using CD Player-Normal PlayTo Unload a CD Search PlayRandom Play Press the Random button on the Remote ControlTo Modify the Program Repeating TracksListening to External Equipment Using External EquipmentsSet the Volume control to the mini- mum position Recording the System’s Source to External EquipmentSetting the Daily Timer Using the TimersSetting the Clock Press the Power buttonSetting the on time Example AM Play a CD or tune in to the desired sta- tion Setting the Sleep TimerPress the Sleep button on the Remote Control Care And Maintenance Possible Cause TroubleshootingSymptom ActionSpecifications Qualityservice Factory Service Center LocationsLimited Warranty AUDIO-1 0201MZMCREHIT