4.Insert two Handrail Bolts (78) with Handrail Washers
(77)and Handrail Bushings (75) into the right Upright
(69)and the right Handrail Spacer (65) as shown. Next, thread the Handrail Bolts into the right Handrail (66). Do not tighten the Handrail Bolts yet.
Attach the left Handrail (not shown) in the same way. Tighten all four Handrail Bolts (78).
5.Press the Lock Knob Sleeve (70) into the left Upright (69).
Make sure that the Lock Pin Collar (72) and the Spring (71) are on the Lock Pin. Insert the Lock Pin into the left Upright (69). Press the Lock Knob Spacer (117) onto left Upright. Tighten the Lock Knob (68) onto the Lock Pin.
6.Look at the Endcap (58). If the left or right foot on the Endcap does not touch the floor, the included thick base pads should be attached to the treadmill as de- scribed below.
Refer to assembly step 2. Lower the treadmill frame and the Uprights (69) as shown. If the left foot of the Endcap (58) was off the ground, remove the two Base Pads (99) from the right Upright (69). Attach the in- cluded thick base pads to the Upright. If the right side of the Endcap was off the ground, attach the thick base pads to the left Upright.
Note: If either side of the Endcap (58) lifts off the floor when the treadmill is used, attach the thick base pads as described.
4 |
|
| 66 |
| 65 |
| 69 |
| 75 |
| 77 |
75 |
|
77 | 78 |
5 |
|
69 |
|
68 |
|
70 |
|
71 |
|
117 | 72 |
| |
| 74 |
6 |
|
Foot |
|
58 |
|
| Foot |
7.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet from damage, place a mat under the treadmill.
7