ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench and your own Phillips screwdriver . For help identifying the assembly hardware, see the hardware drawings below.
|
|
| Handrail Bolt | 3/4” Tek Screw | Panel Screw | |
Console Bolt | ||||||
|
|
|
|
Frame
UprightBolt
Washer | Star Washer |
1.Raise the end of the Frame (not shown) until the tread- mill can be moved on the Front Wheels (66), and care- fully roll the treadmill off the wood pallet.
Insert the Wire Harness (108) through the Upright Plate (115).
With the help of a second person, hold the Upright (111) and the Upright Plate (115) against the Frame Cover (52). See the inset drawing and make sure that the
Upright and the Upright Plate are oriented as shown. Attach the Upright and the Upright Plate with four Upright Bolts (113) with two Star Washers (114).
Do not tighten the Upright Bolts yet.
1 | 115 |
| |
| 111 |
| 111 |
| 66 |
| 108 |
| 114 |
| 52 |
| 115 |
| 114 |
| 113 |
6