ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench 
and your own phillips screwdriver 
,
adjustable wrench 
, and rubber mallet 
. For help identifying the assembly hard- ware, see the drawings below. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 38 and 39. The number following the parentheses is the quantity needed for assem- bly. Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it has been preassembled.
Star Washer | Extension Leg | 1” Tek Screw |
Plastic Spacer | Nut |
|
|
| |
|
| |
Extension Leg Bolt | Console Bolt | |
1.Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the treadmill onto its side as shown. Partially fold the Frame (55) so the treadmill is more stable. Do not fully fold the treadmill until it is completely assembled.
Orient an Extension Leg (97) so the Base Pad (81) is in the position shown, and insert the Extension Leg into the indicated bracket on the base of the Uprights (85). If necessary, use a rubber mallet to align the holes in the Extension Leg with the holes in the bracket.
Attach the Extension Leg (97) with two Extension Leg Bolts (87), two Star Washers (67), and two Extension Leg Nuts (106) as shown. Firmly tighten the
Extension Leg Bolts.
With the help of a second person, carefully tip the tread- mill onto its other side. Attach the other Extension Leg (97) as described above.
1 |
| Bracket |
|
| |
|
| 87 |
| 106 | 67 |
|
| |
|
| 97 |
|
| 81 |
|
| 85 |
|
| 55 |
|
| 97 |
7