IMPORTANT, Please Note | Ironman Fitness 220t specification

LEFT UPRIGHT

CONSOLE

HARNESS

ALLEN BOLT 5/16”-18x15

Assembly

4.Install the Left and Right Uprights to the tread- mill base frame by inserting the upright connect- ing bracket into base frame as seen in Figure 3, using Allen Bolt 5/16”-18 x 70 (Qty. 4), Spring Washer 8 mm (Qty. 4), and Washer 9*16*1.6 mm (Qty. 4).

Next, install the Allen Bolt 5/16”-18 x 15 (Qty. 6), Spring Washer 8 mm (Qty. 6), and Washer 9*16*1.6 mm (Qty. 6). Refer to Figure 3.

Note: Do not tighten hardware in step 3 until step 5 is completed.

IMPORTANT, PLEASE NOTE:

LEFT UPRIGHT

RIGHT UPRIGHT

WASHER 9*16*1.6 mm

SPRING WASHER 8 mm

ALLEN BOLT

5/16”- 18x70

While sliding the upright connecting bracket into the base frame, make sure the harness is installed inside the upright and pay attention not to pinch the wire harness.

WASHER 9*16*1.6 mm

SPRING WASHER 8 mm

Figure 3: Left and Right Upright Installation

5.Connect the Console Harness together as shown in Figure 4. Wiring harness connectors snap together as shown in Figure 2.

Note: The upright console harness wire must be inserted through large hole at front side of upright, before connecting to harness from console assembly.

Connect the Console to the Left and Right Uprights by sliding the Console connecting brackets into the end of the Left and Right Uprights as shown in Figure 4. Tighten into place using 5/16”-18x45 Shoulder Allen Bolt (Qty. 2), Spring Washer 8 mm (Qty. 2), and Washer 9*16*1.6 mm (Qty. 2).

IMPORTANT, PLEASE NOTE:

While connecting the Console to the Left and Right Uprights, pay attention not to pinch the wire harness.

CONSOLE