Horizon Fitness T90 manual Open Hardware BAG, Repeat on the other side, While assembling the masts

INTRODUCTION

IMPORTANT

PRECAUTIONS

P R E - A S S E M B LY

Note: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before

completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended.

A S S E M B LY STEP 1

A S S E M B LY STEP 2

HARDWARE BAG 2 CONTENTS :

BOLT (B)	SPRING WASHER (C)	FLAT WASHER (D)	ARC WASHER (E)
15 mm	15 mm	15 mm	17 mm
Qty: 8	Qty: 8	Qty: 4	Qty: 4

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY
YOU
BEFORE
BEGIN
TREADMILL OPERATION
GUIDELINES
CONDITIONING
&MAINTENANCE
TROUBLESHOOTING
LIMITED
WARRANTY
	

HARDWARE BAG 1 CONTENTS :

BOLT (A) 15 mm Qty: 4

FRAME EXTENSION TUBE

BOLTS (A)

CONSOLE MAST SUPPORT TUBE

AOpen HARDWARE BAG 1.

BSlide the left frame extension tube onto the console mast support tube. Bolt in place using 2 BOLTS (A) on the side.

CRepeat on the other side.

CONSOLE CABLE

(THREAD THROUGH

INSIDE HOLE IN MAST)

RIGHT CONSOLE MAST

CONSOLE MAST

SUPPORT TUBE

ARC WASHER (E)

SPRING WASHER (C)

BOLT (B)

FLAT WASHER (D)

SPRING WASHER (C)

BOLT (B)

AOpen HARDWARE BAG 2.

BSlide the left console mast down onto the console mast support tube. Bolt in place using 2 BOLTS (B), 2 SPRING WASHERS (C), and 2 FLAT WASHERS (D) on the side. Then, bolt in place using 2 BOLTS (B), 2 SPRING WASHERS (C), and 2 ARC WASHERS (E) on the front.

CRepeat on the other side.

Note: On right CONSOLE MAST, the CONSOLE WIRE must be threaded through the mast.

Note: Do not completely tighten any screws or bolts until step 5 is complete!

Note: Be careful not to pinch any wires

while assembling the masts.

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

T90_Rev.1.5.indd 8-9 9/10/08 4:21:01 PM