Horizon Fitness T90 manual Left Console mast and lightly tighten, S E M B Ly C O N T I N U E D

INTRODUCTION IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

A S S E M B LY STEP 3

HARDWARE BAG 3 CONTENTS :

BOLT (F)	SPRING WASHER (C)	FLAT WASHER (D)
25 mm	15 mm	15 mm
Qty: 4	Qty: 4	Qty: 4

CONSOLE
FLAT WASHER (D)	CONSOLE CABLE
SPRING WASHER (C)
BOLT (F)	DO NOT ATTACH
	THIS SIDE UNTIL STEP 3-D

LEFT CONSOLE MAST

A Open HARDWARE BAG 3.

B With running deck in lowered position, place console on the console masts. Align the

A S S E M B LY STEP 3 ( C O N T I N U E D )
STEP D	STEP E
CONSOLE CABLE COVER
	CONSOLE
	BOARD
	CONSOLE
	CABLE
CABLE TIE

STEP F
CABLE TIE	CONSOLE CABLE COVER

A S S E M B LY STEP 4

HARDWARE BAG 4 CONTENTS :

SCREW (I) 15 mm Qty: 2

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

CONDITIONING TROUBLESHOOTING GUIDELINES & MAINTENANCE

brackets that are underneath the console with the top holes of the console masts.

C To assemble the CONSOLE to the left CONSOLE MAST, insert 1 BOLT (F),

1 SPRING WASHER (C) and 1 FLAT WASHER (D) into the 2 holes in the

left CONSOLE mast and lightly tighten.

D Locate CONSOLE CABLE COVER on back of CONSOLE and remove.

E Attach CONSOLE CABLE to CONSOLE BOARD. NOTE: Do not pinch CONSOLE CABLE.

F Replace CONSOLE CABLE COVER on back of CONSOLE and attach excess wire to CABLE TIE.

DECK

LOCK

LATCH

SCREWS (I)

LEFT HANDLEBAR

WATER BOTTLE

HOLDER

TROUBLESHOOTING CONDITIONING MAINTENANCE GUIDELINES

LIMITED

WARRANTY

10

G Repeat step C above to assemble the right console mast to the console.

Note: Do not completely tighten any screws or bolts until step 5 is complete!

AOpen HARDWARE BAG 4.

BAttach DECK LOCK LATCH to LEFT HANDLEBAR using 2 SCREWS (I).

CSlide the WATER BOTTLE HOLDER down into the hole in the CONSOLE and snap together.

11

LIMITED WARRANTY &

T90_Rev.1.5.indd 10-11 9/10/08 4:21:04 PM