2. Identify the Right Upright (92), which is marked | 2 |
| Wire |
|
|
with a “Right” sticker. |
|
|
| ||
Have a second person hold the Right Upright |
|
| Tie | 93 |
|
(92) near the Right Base Cover (102). See the |
|
|
|
| |
inset drawing. Tie the wire tie in the lower end |
| 91 |
|
|
|
of the Right Upright securely around the Upright |
|
|
|
| |
Wire (93). Then, pull the other end of the wire tie |
|
|
|
|
|
out of the upper end of the Right Upright until |
|
|
|
| 92 |
the Upright Wire is routed completely through |
|
|
|
| |
the Right Upright. |
|
|
|
|
|
Gently pull up on the Upright Wire (93) as you |
|
|
|
| 102 |
set the Right Upright (92) on the Base (103) in- |
|
|
|
| |
side the Right Base Cover (102). Be careful not |
|
|
|
| 103 |
to pinch the Upright Wire. |
|
|
|
| |
Attach the Right Upright (92) to the Base (103) |
|
|
|
|
|
with two 3/8" x 3 3/4" Patch Bolts (5) and two |
|
|
|
| 6 |
3/8" Star Washers (6). Note: It may be neces- |
|
|
|
| |
sary to tip the top of the Right Upright forward |
|
|
|
|
|
slightly as you thread the Patch Bolts into it. Do | 92 | 93 |
|
| 5 |
not tighten the Patch Bolts yet. |
|
| |||
Attach the Left Upright (91) in the same way. |
| Wire |
|
|
|
Note: There are no wires on the left side. |
| Tie |
|
|
|
3. With the help of a second person, lower the | 3 |
|
|
|
|
treadmill off the cardboard stand. The stand will |
|
|
|
| |
be used again in assembly step 9. |
|
|
| 89 |
|
Identify the Left Upright Sleeve (89) and the |
| 91 |
|
| |
|
| “Left” |
| ||
Right Upright Sleeve (90); the Upright Sleeves |
|
|
| “Right” | |
are labeled “Left” and “Right.” Slide the Left |
|
|
|
| |
Upright Sleeve onto the Left Upright (91), and |
|
|
|
| 90 |
slide the Right Upright Sleeve onto the Right |
|
|
|
| |
Upright (92). |
|
|
|
| 92 |
|
|
|
|
| |
|
|
|
|
| Cardboard |
|
|
|
|
| Stand |
| 7 |
|
|
|
|