Reebok Fitness RBTL76009.0 manual Measure your heart rate if desired. Before using

Page 16

4.Change the incline of the treadmill as desired. To change the incline of the treadmill, press the Incline increase and decrease buttons or one of the numbered One Touch Incline buttons. Each time you press the Incline increase or decrease button, the incline will change by 0.5 percent. If you press one of the numbered One Touch Incline but- tons, the treadmill will adjust to the selected incline setting. Note: After you press the button, it may take a moment for the treadmill to reach the se- lected incline setting.

5.Follow your progress with the displays. When the

manual mode is se- lected, the

upper half ofTrack the display

will show a

track that represents 1/4 mile (400 meters). As you walk or run, indicators will appear in succession around the track until the entire track appears. The track will then disappear and the indicators will again begin to appear in succession.

The upper half of the display can also show the elapsed time, the distance you have walked or run, the speed of the walking belt, the approximate number of calories you have burned, your pace in minutes per mile, and the incline of the treadmill. Press the Display button repeatedly until the de- sired workout information appears. Note: While in- formation is shown in the upper half of the display, the same information will not be shown in the lower half of the display.

The lower left corner of the display will show the elapsed time, the dis- tance that you have walked or run, and the in- cline level of the treadmill.

Note: When a weight loss workout is selected, the display will show the time remaining in the workout instead of the elapsed time.

The lower right corner of the display will show the approximate number of calories you have burned, the speed of the

walking belt, and your pace in minutes per mile. The lower right corner of the display will also show your heart rate when you use the handgrip pulse sensor.

Adjust the volume with the Vol increase and de- crease buttons on the console.

To reset the display, press the Stop button, remove the key, and then reinsert the key.

6.Measure your heart rate if desired. Before using the

handgrip pulse sensor, remove the sheets of clear plastic from the metal con-

tacts. In addition, Metal Contacts make sure that

your hands are clean.

To measure your heart rate, stand on the foot rails and place your hands on the metal contacts— avoid moving your hands. When your pulse is detected, the heart symbol in the display will begin to flash each time your heart beats, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate read- ing, continue to hold the contacts for at least 15 seconds.

7. When you are finished exercising, remove the key from the console.

Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest set- ting or you may damage the treadmill when you fold it to the storage position. Next, remove the key from the console and put it in a secure place. When you are finished using the treadmill, switch the reset/off circuit breaker to the off position and unplug the power cord. IMPORTANT: If you do not do this, the treadmillʼs electrical compo- nents may wear prematurely.

16

Image 16
Contents QUESTIONS? Model No. RBTL76009.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Page Before YOU Begin Assembly Do not fully fold the Frame yet Make sure that the power cord is unpluggedTighten the Nut the Wheel must turn freely Correct Incorrect Touch the Upright do not fully tighten Patch Bolts yetPatch Bolts yet Star Washer 13. Do not tighten the Patch Bolts yet Again. if the Connectors are not CON Be Damaged When YOU Turn onStar Washers 12. Do not tighten the Screws Yet Nected PROPERLY, the Console MAYScrews before tightening any of them HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeMeasure your heart rate if desired. Before using HOW to USE a Weight Loss Workout Select one of the weight loss workoutsHOW to USE AN Ifit Workout Insert an iFit card and select a workoutInformation Mode HOW to USE the Stereo Sound SystemHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Problem The walking belt slows when walked on TopProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. RBTL76009.0 Key No. Qty DescriptionQty Exploded Drawing A-Model No. RBTL76009.0 R0110A Exploded Drawing B-Model No. RBTL76009.0 R0110A Exploded Drawing C-Model No. RBTL76009.0 R0110A Exploded Drawing D-Model No. RBTL76009.0 R0110A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT