Remove the three #8 x 3/4" Screws (1) and care- |
|
| 1 |
fully pivot the Motor Hood (62) off. |
| 62 | |
|
|
| |
Locate the Reed Switch (73) and the Magnet (47) |
|
|
|
on the left side of the Pulley (48). Turn the Pulley |
|
|
|
until the Magnet is aligned with the Reed Switch. |
|
|
|
Make sure that the gap between the Magnet and | 1/8 in. |
|
|
the Reed Switch is about 1/8 in. (3 mm). If nec- |
|
| |
essary, loosen the #8 x 3/4" Truss Head Screw | 73 |
| 47 |
(18), move the Reed Switch slightly, and then |
| ||
retighten the Screw. Reattach the Motor Hood (not |
|
| 48 |
shown). Reattach the #8 x 2" Screws (not shown) if | Top |
|
|
necessary. Run the treadmill for a few minutes to |
|
| |
check for a correct speed reading. | View |
|
|
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds,
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a
b. If the walking belt is overtightened, treadmill perfor- b mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both idler roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
c. If the walking belt still slows when walked on, see the front cover of this manual.
23