Spirit XE395 owner manual Incline Rail & Console Mast, Hardware

STEP1:Incline Rail & Console Mast

1.Slide the Incline Rail Assembly (2) into the U channel of the Main Frame (1). Be very careful not to damage the wires that exit each part.

2.Connect the Incline Rail Assembly (2) horizontally to the U channel of the Main Frame (1) with two Hex Head Bolts (77), two Flat Washers (96), and two Nyloc Nuts (89). Secure it vertically with four Hex Head Bolts (167), four split washers (178), four Flat Washers (100), and four star washers (179).Tighten using the wrenches provided (124 & 129).

3.Connect the Incline Motor wires (37 & 38) to the wiring harness & black wire that exits the Incline Rail Assembly (2). Push the excess cable inside the U channel.

4.Guide the twist tie that is attached to the Computer Cables (36 & 39) bundle through the Console Mast Cover (49) and the bottom of the Console Mast (12) until it exits the top of the steel tube Note: make sure the console mast cover is positioned like the illustration. Secure the Console Mast (12) by loosely threading two Hex Head Bolts (76) from the front and two Curved Washers (104) first.Then secure the mast from the side by loosely threading a Hex Head Bolt (75) and a Split Washer (128); Note: there is one bolt already installed in the receiving bracket that will engage with the slot at the bottom of the Console Mast.Tighten the bolt from the left side last.

5.Tighten the two front bolts first, then the side bolts with the wrench (124). Secure the Console Mast Cover (49) over the top of the plastic side covers (50 & 51).

6.Untie the twist tie, which is attached to the Computer Cables (36 & 39). Plug in the connectors of the two Hand pulse cables (44), Computer cable (36 & 39), Resistance cable (146), and Incline cable (146-1) in the bottom of the Console (32). Secure the Console (32) onto the mounting plate with four Phillips Head Screws (85).Tighten them with the Phillips Head Screw Driver (126).

HARDWARE

#96. 3/8” x 19 x 1.5T	#100. 5/16” x 20 x 1.5T	#104. 3/8” x 23 x 1.5T	#128. 3/8” x 2T	#85. M5 x 10mm
Flat Washer	Flat Washer	Curved Washer	Split Washer	Phillips Head Screw
(2 pcs)	(4 pcs)	(2 pcs)	(1 pc)	(4 pcs)

#89. 3/8” x 7T	#178. 5/16” x 1.5T	#179. 5/16”	#76. 3/8” x 3/4”
Nyloc Nut	Split Washer	Star Washer	Hex Head Bolt
(2 pcs)	(4 pcs)	(4 pcs)	(2 pcs)

#77. 3/8” x 1-1/2”	#167. 5/16” x 2-1/4”	#75. 3/8” x 2-1/4”
Hex Head Bolt	Hex Head Bolt	Hex Head Bolt
(2 pcs)	(4 pcs)	(1 pc)

XE395 Elliptical Trainer 6