Gold's Gym CWTL05607.0 manual Troubleshooting, Problem The power turns off during use

Page 25

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 11). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 11. Important: The treadmill is not com- patible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c.Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes, and then press the switch back in.

PROBLEM: The power turns off during use

c

Tripped

Reset

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, see the front cover of this manual.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 20 to turn off the demo mode.

PROBLEM: The display of the console does not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE POWER CORD. Next, carefully lower the Uprights (84, 107). Remove the two indicated #8 x 3/4" Screws

(3). Note: A Phillips screwdriver with a shaft at least 8 in. (20 cm) long is needed.

a

84

 

107

 

 

3

 

3

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Model No. CWTL05607.0 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Before YOU Begin Assembly Tighten the Bolts yet Be careful not to pinch the Upright WireSole MAY be Damaged When Not Connected PROPERLY, the CONTop View To overtighten the BoltsPage HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerSelect the manual mode Insert the key into the consoleFollow your progress with the display Change the incline of the treadmill as desiredTurn on the fan if desired Measure your heart rate if desiredSelect one of the six cross trainer workouts HOW to USE a Cross Trainer WorkoutPress the Start button to start the workout Continue the cross trainer workout Perform the first strength exercise when promptedSelect a distance workout HOW to USE a Distance WorkoutHOW to USE a Preset Workout Information Mode Optional Chest Pulse Sensor HOW to Adjust the Cushioning SystemHOW to USE the Upper Body Arms HOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingTop Problem The walking belt slows when walked onPage Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Qty Description R0208ADescription Exploded Drawing A-Model No. CWTL05607.0 R0208A Exploded Drawing B-Model No. CWTL05607.0 R0208A Exploded Drawing C-Model No. CWTL05607.0 R0208A Exploded Drawing D-Model No. CWTL05607.0 R0208A Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT
Top Page Image Contents