Assembly, Bolts yet | Healthrider HMTL39906.1 instruction

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key		and your own Phillips screwdriver	, rubber mal-
let	, adjustable wrench	, and needlenose pliers	.

For help identifying the assembly hardware, see the drawings below. If a part is not in the parts bag, check to see if it has been pre-assembled.To avoid damaging plastic parts, do not use power tools for assembly.

1/2" Screw (48)–2	3/4" Screw (2)–7	1" Tek Screw (39)–8	1" Upright
			Bolt (76)–2
Silver Ground		5/16" Star Washer
Screw (75)–1		5/16" Star Washer
Screw (75)–1	Nut (13)–2	(95)–8	Wheel Bolt (64)–2
	Nut (13)–2	(95)–8	Wheel Bolt (64)–2
3" Upright Bolt (21)–2		Handrail Bolt (37)–4

1.Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the tread- mill onto its left side as shown. Partially fold the Frame

(86)so the treadmill is more stable. Do not fully fold the treadmill until it is completely assembled.

See the inset drawing. Make sure that there are two U- Nuts (99) in the lower end of each Upright (7, 90). Identify the Right Upright (90) with the sticker. Hold the Right Upright near the right side of the Upright Base (69), with the Right Upright turned as shown. Feed the colored tie and Upright Wire (42) into the lower end of the Right Upright and out of the upper end. If necessary, use needlenose pliers to pull the tie out the upper end.

Pull on the end of the Upright Wire (42) to remove any slack as you hold the Right Upright (90) against the Upright Base (69); be careful not to pinch the Upright Wire. Start a 3" Upright Bolt (21) and a 1" Upright Bolt

(76)with 5/16" Star Washers (95) into the Upright Base and the Right Upright as shown. Do not tighten the

Bolts yet.

1
Tie
90
42	69
42
	95	21
	95
		76
86
	7, 90
		99