Healthrider HMTL39906.1 manual Remove the colored tie from the Upright Wire Large Hole

5.Attach two Round Base Pads (57) and an Extension Leg Pad (61) to the Upright Base (69) and Extension Leg (63) with four 1" Tek Screws (39) as shown.

6.Attach a Wheel (66) to the Upright Base (69) with a Wheel Bolt (64) and a Nut (13) as shown. Do not over- tighten the Wheel Bolt; the Wheel should turn freely.

With the help of a second person, carefully tip the tread- mill up so the Round Base Pads (57) are on the floor.

7.Identify the Right Handrail (72), which has a large hole in the left side. Feed the Upright Wire (42) into the hole in the bottom of the Right Handrail and out of the large hole in the side. Note: It may be helpful to use needlenose pliers to pull the colored wire and Upright Wire out of the hole.

Then, attach the Right Handrail (72) to the Right Upright

(90)with two Handrail Bolts (37) and two 5/16" Star Washers (95).

Attach the Left Handrail (71) to the Left Upright (7) in the same way. Note: There is not a wire on the left side.

Remove the colored tie from the Upright Wire (42).

5
69
57
39	63
39
39	61
6
64
66
69
57
13

7
37	71
95		Large
	42	Hole
7	37
	95
	72
		90

8