Healthrider HMTL39906.1 manual

Page 7

2.Attach two Round Base Pads (57) and an Extension Leg Pad (61) to the Upright Base (69) and Extension Leg (63) with four 1" Tek Screws (39) as shown.

3.Attach a Wheel (66) to the Upright Base (69) with a Wheel Bolt (64) and a Nut (13) as shown. Do not over- tighten the Wheel Bolt; the Wheel should turn freely.

With the help of a second person, carefully tip the tread- mill onto its other side.

4.Partially fold the Frame (86) so the treadmill is more sta- ble. Do not fully fold the treadmill until it is com- pletely assembled.

Hold the Left Upright (7) against the Upright Base (69). Start a 3" Upright Bolt (21) and a 1" Upright Bolt (76) with 5/16" Star Washers (95) into the Upright Base and the Left Upright as shown. Do not tighten the Bolts yet.

2
		57
		69
	63
			39
		39
	61	39
	61
3			64
			64
		69	66
		69
			13

4
69	7
69
21
76	95
	86

7

Image 7

Contents Model No. HMTL39906.1 Serial No QUESTIONS?Table of Contents Important Precautions Page Before YOU Begin Make sure that the power cord is unplugged AssemblyBolts yet Page Remove the colored tie from the Upright Wire Large Hole Ground Wire Small Hole Sleeve Connector Top View HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerRate, stand on Foot rails Measure your heart rate if desiredSelect a personal trainer program HOW to USE a Personal Trainer ProgramPress the Start button to start the program Information Mode HOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingTop Problem The walking belt slows when walked on Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Key Qty Description Part LIST-Model No. HMTL39906.1Exploded Exploded Drawing B-Model No. HMTL39906.1 R0607A Exploded Drawing C-Model No. HMTL39906.1 R0607A Exploded Drawing D-Model No. HMTL39906.1 R0607A Ordering Replacement Parts