Healthrider HRTL89406.0 manual Important Precautions

Page 3

IMPORTANT PRECAUTIONS

WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and information before operating the treadmill.

1.It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of all warnings and precautions.

2.Use the treadmill only as described.

3.Place the treadmill on a level surface, with at least eight feet of clearance behind it and two feet on each side. Do not place the treadmill on any surface that blocks air openings. To protect the floor or carpet from damage, place a mat under the treadmill.

4.Keep the treadmill indoors, away from mois- ture and dust. Do not put the treadmill in a garage or covered patio, or near water.

5.Do not operate the treadmill where aerosol products are used or where oxygen is being administered.

6.Keep children under the age of 12 and pets away from the treadmill at all times.

7.The treadmill should not be used by persons weighing more than 325 pounds.

8.Never allow more than one person on the treadmill at a time.

9.Wear appropriate exercise clothes when using the treadmill. Do not wear loose clothes that could become caught in the treadmill. Athletic support clothes are recommended for both men and women. Always wear athletic shoes. Never use the treadmill with bare feet, wearing only stockings, or in sandals.

10.When connecting the power cord (see page 12), plug the power cord into a surge suppressor (not included) and plug the surge suppressor into a grounded circuit capable of carrying 15 or more amps. No other appliance should be on the same circuit. Do not use an extension cord.

11.Use only a single-outlet surge suppressor that meets all of the specifications described on page 12. To purchase a surge suppressor, see your local HealthRider dealer or call the toll- free telephone number on the front cover of this manual and order part number 146148, or see your local electronics store.

12.Failure to use a properly functioning surge suppressor could result in damage to the con- trol system of the treadmill. If the control sys- tem is damaged, the walking belt may change speed, accelerate, or stop unexpectedly, which may result in a fall and serious injury.

13.Keep the power cord and the surge suppres- sor away from heated surfaces.

14.Never move the walking belt while the power is turned off. Do not operate the treadmill if the power cord or plug is damaged, or if the treadmill is not working properly. (See TROUBLESHOOTING on page 26 if the tread- mill is not working properly.)

15.Read, understand, and test the emergency stop procedure before using the treadmill (see HOW TO TURN ON THE POWER on page 14).

16.Never start the treadmill while you are stand- ing on the walking belt. Always hold the handrails while using the treadmill.

17.The treadmill is capable of high speeds. Adjust the speed in small increments to avoid sudden jumps in speed.

18.The pulse sensors are not a medical devices. Various factors, including the user's move- ment, may affect the accuracy of heart rate readings. The pulse sensors are intended only as an exercise aid in determining heart rate trends in general.

19.Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and switch the reset/off circuit breaker to the “off” position when the tread- mill is not in use. (See the drawing on page 6 for the location of the reset/off circuit breaker.)

20.Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 7, and HOW TO FOLD AND MOVE THE TREADMILL on page 25.) You must be able to safely lift 45 pounds (20 kg) to raise, lower, or move the treadmill.

3

Image 3
Contents QUESTIONS? Model No. HRTL89406.0 Serial NoCall TOLL-FREE Table of Contents Important Precautions Page Power Lines Before YOU Begin Make sure that the power cord is unplugged AssemblyTop Page HOW to Connect AN Antenna HOW to Connect a 75 OHM Catv CableHOW to Connect a VCR Chest Pulse Sensor Troubleshooting HOW to USE the Chest Pulse SensorHOW to PUT on the Chest Pulse Sensor Chest Pulse Sensor Care and MaintenanceOperation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerContacts for about 15 seconds Follow your progress with the displaysMeasure your heart rate if desired Pulse sensor. Next, stand on the foot railsWhenkey. you are finished exercising, remove HOW to USE a Preset ProgramSelect a preset program Turn on the fan if desiredWorkout Intensity bar Incline settings for the next segmentHOW to USE a Distance Program Select a Distance programTurn on the fans if desired HOW to Create a Custom Program Programsettings. the desired speed and inclineSelect a Custom program HOW to USE a Custom Program HOW to USE a Pulse Program Adjust the maximum target heart rate setting if DesiredSelect a Pulse program Follow your progress with the displays Workout Intensity bar Press the Channel buttons to select Desired channel HOW to Operate the Personal TelevisionPress the Volume buttons to adjust the volume Press the On/Off button to turn on TelevisionPress the On/Off button again and add or Delete channels HOW to USE the Information ModeHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Move the TreadmillProblem The power turns off during use TroubleshootingTop View Problem The walking belt slows when walked on Problem The chest pulse sensor does not function properly Problem Television reception is poorExercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesQty Description R1106AOrdering Replacement Parts Exploded Exploded Drawing B-Model No. HRTL89406.0 R1106A Exploded Drawing C-Model No. HRTL89406.0 R1106A Exploded Drawing D-Model No. HRTL89406.0 R1106A Limited Warranty