Healthrider HRTL39305.0 manual Troubleshooting, Problem The power turns off during use, Top

Page 22

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 9). Use only a single-outlet surge suppressor that meets all of the specifications described on page 9. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the treadmill

c

 

near the power cord. If the switch protrudes as

 

 

 

shown, the circuit breaker has tripped. To reset the

Tripped

Reset

circuit breaker, wait for five minutes and then press

 

 

the switch back in.

 

 

PROBLEM: The power turns off during use

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the

circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key fully into the console.

d. If the treadmill still will not run, see the front cover of this manual.

PROBLEM: The speed display on the console does not function properly

SOLUTION: a. Remove the key and UNPLUG THE POWER CORD.

a

 

Remove the hood from the treadmill. Locate the Reed

 

1/8”

 

Switch (21) and the Magnet (43) on the left side of the

42

Pulley (42). Turn the Pulley until the Magnet is aligned

76

with the Reed Switch. Make sure that the gap be-

21

43

tween the Magnet and the Reed Switch is about

 

 

1/8”. If necessary, loosen the 3/4” Screw (76), move

Top

 

the Reed Switch slightly, and then retighten the

 

Screw. Reattach the hood, and run the treadmill for a

View

 

few minutes to check for a correct speed reading.

 

 

22

Image 22
Contents Model No. HRTL39305.0 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Right Side Before YOU BeginLeft Side Assembly Driver Adjustable wrench Wire cuttersRight Upright 10 to discharge any static Top View HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeHOW to USE Personal Trainer Programs When the program is completed, remove Key from the console Follow your progress with the displaysHOW to Connect Your Portable Stereo HOW to Connect Your Home Stereo HOW to Connect Your Computer HOW to Connect Your VCR Adapter Audio CablePrograms VCRHOW to USE Programs Directly from OUR WEB SiteInformation Mode HOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingTop Problem The walking belt slows when walked on Workout Guidelines Conditioning GuidelinesExercise Intensity Exercise FrequencySuggested Stretches R0905A Key Qty DescriptionPart Identification Chart Exploded DRAWING-Model No. HRTL39305.0 115 108 110 105 113 114 102 107 104 101 Limited Warranty