If the speed or incline settings are too high or too low, you can manually override the settings at any time by pressing the Speed or Incline buttons on the console. However, when the next ÒchirpÓ is heard, the speed and/or incline will change to the next settings of the CD or video program.
To stop the walking belt at any time, press a Stop button on the console. The Time/Segment Time display will begin to flash. To restart the program, press the Start button. After a moment, the walk- ing belt will begin to move at 1.0 mph. When the next ÒchirpÓ is heard, the speed and incline will change to the next settings of the CD or video program. The program can also be stopped by pressing the Stop button on your CD player or VCR.
When the CD or video program is completed, the walking belt will stop and the Time/Segment Time display will begin to flash. Note: To use another CD or video program, press a Stop button or re- move the key and go to step 1 on page 17.
Note: If the speed or incline of the treadmill does not change when a ÒchirpÓ is heard:
¥make sure that the IFit.com indicator is lit and that the Time/Segment Time display is not flashing. If the Time/Segment Time display is flashing, press the Start button or the Speed ▲ button on the console
¥adjust the volume of your CD player or VCR. If the volume is too high or too low, the console may not detect the program signals
¥make sure that the audio cable is properly connected, that it is fully plugged in, and that it is not wrapped around a power cord
¥if you are using your portable CD player and the CD skips, set the CD player on the floor or another flat surface instead of on the console.
5Follow your progress with the four displays.
See step 5 on page 11.
6Whenkey. the program is completed, remove the
Step onto the foot rails and make sure that the in- cline of the treadmill is at 1.5%. The incline must be at 1.5% when the treadmill is raised to the storage position. Next, remove the key from the console and put it in a safe place. Note: If the dis- plays and indicators on the console remain lit after the key is removed, the console is in the ÒdemoÓ mode. Refer to page 20 and turn off the demo mode.
When you are finished using the treadmill, move the on/off switch near the power cord to the off position and unplug the power cord.
18