O W N E R ' S M A N U A L • J 9 • J 9 F
•Press any function key to exit the Set mode. NOTE! Pressing the Set key during an exercise
will stop the belt and finish the exercise.
The Reset key resets energy consumption, time and distance displays for all exercises.
D I S P L AY
SEPARATE DISPLAYS
1.SPEED
Running deck speed measured in kilometres or miles per hour
2. TIME
Elapsed time at 1 second intervals
3. DISTANCE
Accumulated distance in kilometers or miles (0.0-999.9).
MAIN DISPLAY
1.Profile display: the letters beside the display indicate which profile is being displayed (mph, km/h = speed; kcal/min = energy consumption measurement during workout; heart =
2. Letters indicating a selected function: Manual Control =
3. Number line: kcal = energy consumption; arrow up/down = running deck elevation; heart = heart- rate level. If
ERROR CODES
The user interface will display information about any operational faults. An error code begins with the abbreviation Err.
11Motor heat protection off: Please check running deck lubrication.
13Running deck speed exceeds set value: Please follow this manual’s instructions on using the device.
15Running deck does not respond to controls: Please check running deck lubrication and follow this manual’s instructions on using the device.
71Lift motor fault or lifting motor overload protection off: Please switch the device off for 5 minutes and then restart. If the error message does not disappear, please contact your local Tunturi distributor.
Remove the error code by pressing the RESET key. If any of these error codes appears repeatedly despite servicing, or if a code other than the above is displayed constantly, please contact your Tunturi dealer.
POSITION SPEED CONTROL (PSC)
Position Speed Control (PSC ) allows you to adjust running track speed by changing your position on the track. Move to the front of the track and it accelerates, and as you move back the track itself slows down. When you are walking or running in the middle section of the track the speed stays steady.
NOTE! You must wear a Polar heart rate belt when you use PSC ! A blinking square in the Heart Rate display indicates that heart rate measurement is in operation.
NOTE! Attach the holder of the safety tether key carefully to your shirt whenever you are using PSC. Adjust the length of the safety tether key wire so that it will be detached from the meter, if you move too far back.
NOTE! If you are exercising with PSC , there must not be another heart rate transmitter near the treadmill (minimum distance 2 m); the simultaneous signals of two transmitters endanger user safety by interfering with the PSC .
1.Start the use of PSC by setting the speed zone limits. Press the PSC key.
• PSC ON is displayed. Press OK .
• SET UP YES is displayed. Press OK.
• POSITION 1 YES is displayed. Step on the track as shown in figure Pos 1, the tips of your shoes level with the front edge of the roughened side panels. Press OK , and the meter will measure your
distance on the basis of the heart rate signal. Measurement takes 6 seconds, and after that POSITION 2 YES is displayed. Position yourself as shown in figure Pos 2, the heels of your shoes level with the rear edge of the roughened side panels. Press OK , and the meter will measure your distance on the basis of the heart rate signal. Measurement takes 6 seconds, and after that SET UP READY is displayed.
Pos 1 | Pos 2 |
•If the meter cannot receive the heart rate signal or there are problems in measuring the distance, the meter will return to the SET UP display. In case of such an error, the text Hr Err is displayed for 5 seconds.
6