4.Make sure that the two Upright Bushings (8) are inserted into the Upright (2). Apply a thin film of the included grease along the length of the Pivot Axle
(11). Insert the Pivot Axle into the Upright Bushings and the Upright.
Identify the Right Pivot Arm (7), which is marked with a sticker that has an “R” on it. Make sure that there are two Pivot Bushings (9) in the Right Pivot Arm.
Slide the Right Pivot Arm onto the Pivot Axle (11), making sure that it is oriented as shown. Put a Pivot Washer (54) onto an M8 x 19mm Button Screw (10) and tighten the Button Screw into the Pivot Axle.
5.Identify the Left Pivot Arm (6), which is marked with a sticker that has an “L” on it. Make sure that there are two Pivot Bushings (9) in the Left Pivot Arm. Slide the Left Pivot Arm onto the Pivot Axle (11), making sure that it is oriented as shown. Put a Pivot Washer (54) onto an M8 x 19mm Button Screw (10) and tighten the Button Screw into the Pivot Axle.
6.Insert a Handlebar (12) into the Right Pivot Arm (7). Slide the Foam Grip (13) up to expose the mounting holes. Secure the Handlebar with two M5 x 30mm Button Bolts (51) and two M5 Nylon Locknuts (52). Slide the Foam Grip down over the Button Bolts and Nylon Locknuts.
Attach the other Handlebar (12) to the Left Pivot Arm
(6)in the same manner.
7
4 |
|
|
| 54 |
|
|
| 8 | 9 |
|
|
| 10 | |
|
|
|
| |
|
|
|
| 9 |
|
| 8 |
|
|
| 11 |
|
| 7 |
|
|
| 2 | |
|
|
|
| |
| Grease |
|
|
|
5 |
|
|
|
|
|
| 11 |
|
|
| 9 |
|
|
|
| 10 | 9 |
|
|
|
|
|
| |
| 54 | 6 |
|
|
|
|
|
| |
6 |
|
|
|
|
|
|
|
| 13 |
|
| 12 |
|
|
|
| 52 |
| 51 |
|
|
|
| |
|
|
|
| 7 |
| 6 |
|
|
|