ASSEMBLY
Make Things Easier for Yourself
This manual is designed to ensure that the weight bench can be assembled successfully by anyone. Most people find that by setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two people.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
The following tools (not included) are required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
•Lubricant, such as grease or petroleum jelly, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
1.Before assembling the weight bench, be sure that you have read and understand the infor- mation in the box above.
Press two 75mm x 50mm Inner Caps (20) into the lower end of each Upright (4).
Orient the Uprights (4) with the adjustment holes on the outside.
Position the Crossbar (3) between the two Uprights (4). Note: Make sure the warning decal on the Crossbar is in the position shown. Attach the Crossbar to each Upright with four M10 x 95mm Bolts (34), two Support Plates (21), and four M10 Nylon Locknuts (35). Do not tighten the Nylon Locknuts yet.
1 |
|
|
|
| Adjustment |
| 4 | Holes |
Decal |
| 35 |
| 21 | |
3 |
| |
|
| |
| 21 | 35 |
|
| |
34 |
|
|
34 | 20 | |
| 20 |
|
6