7.Apply a liberal amount of grease to the barrel of each M8 x 79mm Bolt Set (65).
Identify the Left Pedal (10), which has a notch near the right side. Place the Left Pedal on the Left Pedal Leg (4). Have a second person hold the bracket on the left Upper Body Leg (31) inside of the bracket on the Left Pedal Leg, and hold a Pedal Wheel (28) inside of the bracket on the left Upper Body Leg.
Align the indicated holes, and attach the Left Pedal (10), the left Upper Body Leg (31), and the Wheel (28) to the Left Pedal Leg (4) with an M8 x 79mm Bolt Set (65). Attach the other end of the Left Pedal to the Left Pedal Leg with two M8 x 56mm Button Screws (83) and two M8 Split Washers (30).
Repeat this step on the right side of the elliptical exerciser.
See step 4. Tighten the two M10 x 108mm Button Screws (70).
8.Have another person hold the Console (17) near the Upright (2).
Connect the Upper Wire Harness (115) to the wire har- ness on the Console (17). Connect the Pulse Extension Wire (114) to the pulse wire on the Console.
Carefully insert all excess wiring down into the Upright
(2). Attach the Console to the Upright with four M4 x 16mm Round Head Screws (69). (Note: The Round Head Screws may be found in the console box.) Be careful to avoid pinching the wires.
9.Plug the Power Cord (116) into the Power Socket (117) at the rear of the elliptical exerciser.
7 |
|
|
31 |
|
|
Holes |
| Notch |
|
| 5 |
|
| 10 |
Grease | 4 |
|
65 |
| |
|
| |
28 |
| 30 |
65 |
| |
|
| |
|
| 83 |
8 |
|
|
Do not pinch | 17 |
|
the wires |
| |
|
| |
during this step. |
|
|
114 |
|
|
69 |
|
|
|
| 115 |
|
| 2 |
9 |
|
|
| 117 | 116 |
10.Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
8