ASSEMBLY
Place all parts of the ski exerciser in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. Assembly requires only the included flat wrench tool.
1.Attach the Leg Bracket (2) to the Front Frame (1) with two M10 x 16mm Hex Screws (73) and two M10 Washers (72) as shown. Make sure that the ends of the Leg Bracket angle away from the Front Frame and that the indicated hole is in the position shown.
2.Insert a Leg (76) up into the square opening in either end of the Leg Bracket (2). Align the second hole from the bottom of the Leg with the hole in the Leg Bracket, and insert the straight end of a Leg Pin (74) into the holes. Make sure that the Leg Pin goes completely through the holes and that the bent end of the Leg Pin points toward the floor. Rotate the Leg Pin to secure it around the Leg.
Slide an Incline Clamp (92) onto the indicated stud and into the slots in the Leg Bracket (2). Tighten an Incline Knob (93) with an Incline Washer (94) onto the stud.
Attach the other Leg (76) in the same way.
3.Lift the Upper Body Arm (27) slightly so it will not catch on the Front Frame (1), and raise the Upright (16) to the position shown. The Upright will snap into place when it is positioned correctly. Make sure that the M8 Push Nut
(18)is between the Upright and the Front Frame.
Tighten the two Upright Knobs (17). Note: Each Upright Knob functions like a wrench. Turn the Upright Knob clockwise, pull it away from the Upright (16), turn it counterclockwise, push it toward the Upright, and then turn it clockwise again. Repeat this procedure until the Upright Knob is tight.
1 |
|
2 |
|
| 1 |
Hole | 72 |
73 |
|
2 |
|
Stud | 2 |
92 |
|
94 | Slots |
| |
93 | 74 |
| |
76 |
|
| 76 |
3 |
|
27 | 16 |
17 |
|
18 | 1 |
| |
| 17 |
4