PROBLEM: The arm cord assembly makes a chattering or screeching sound or the resistance knob loosens.
SOLUTION: a. Check the order of the parts in the pulley assembly, and confirm that all parts are present. The parts from the pulley to the resistance knob should be as follows: M10 washer, thrust washer, M10 washer, and spring.
b.Roughen the surface of the resistance pad with
c.Oil the M10 washers and the thrust washer if needed.
PROBLEM: The flywheel and/or the resistance strap offers no resistance.
SOLUTION: a. Check the routing of the resistance strap.
b.Make sure that the flywheel is tight. Remove the “U” bolt cover from the flywheel (see step 8 on page 9). Evenly tighten the two M6 nuts located on the right side of the flywheel.
PROBLEM: The skis slip.
SOLUTION: a. Wipe off any excess oil.
b.Clean the bottoms of the skis with a dry cloth and a small amount of mineral spirits or paint thinner.
c.Make sure that the flywheel is tight. Remove the “U” bolt cover from the flywheel (see step 8 on page 9). Evenly tighten the two M6 nuts located on the right side of the flywheel.
PROBLEM: The rollers squeak or stick.
SOLUTION: See GENERAL LUBRICATION on page 10.
12