4.Slide the Press Frame (102) into the Seat Frame (106).
Press a 2” Square Inner Cap (112) into the indicated end of the Press Frame (102). Press a 2” Square Angled Cap (126) onto the other end of the Press Frame.
Note: Make sure the Support Plate (135 [not shown]) is inside the 2” Square Angled Cap (126).
5.Attach the Seat Frame (106) to the Press Base (101) with four 3/8” x 3” Carriage Bolts (115) and four 3/8” Nylon Locknuts (118).
6.Lubricate two 3/8” x 3 1/4” Bolts (124). Attach the Rear and Forward Press Uprights (104, 105) to the Press Base (101) with the Bolts and two 3/8” Nylon Locknuts (118). Note: the Rear Press Upright has an extra hole halfway down the side.
Press two 2” Square Inner Caps (112) into the Rear and Forward Press Uprights (104, 105).
Do not over tighten the Bolts; the Press Uprights must be able to pivot freely.
7.Lubricate two 3/8” x 3 1/4” Bolts (124). Attach the Press Plates (108) to the Rear and Forward Press Uprights (104, 105) with the Bolts and two 3/8” Jam Nuts (122).
Do not over tighten the Bolts; the Press Uprights must be able to pivot freely.
4 |
|
|
|
| 129 |
|
|
|
|
| 106 |
| 112 |
|
|
|
|
| 126 |
|
| 102 |
|
5 |
|
|
|
115 | 106 |
| |
|
| 115 |
|
| 118 |
|
|
| 101 | 118 |
|
6 |
|
| 112 |
|
| 104 |
|
|
|
| 105 |
| 101 |
| 124 |
| 118 | Lubricate | |
|
| ||
7 |
|
|
|
|
|
| 124 |
|
|
| Lubricate |
| 104 |
|
|
|
|
| 108 |
122 | 108 |
| 105 |
7