Cable Assembly
8.Open the parts bag labeled “CABLE ASSEMBLY.”
Attach the Cable (133) to the indicated hole in the Press Base (101) with a 3/8” x 3” Bolt (117), two 3/8” Washers (120), a 5/8” x 1/4” Spacer (127), and a 3/8” Nylon Jam Nut (122). Note: Do not over tighten the
Jam Nut; the Cable must be able to pivot easily.
9.Wrap the Cable (133) around a 4” Pulley (113) and attach the Pulley and a Cable Trap (116) to the Rear Press Upright (104) with a 3/8” x 3 3/4” Bolt (110), a 3/8” Washer (120), and a 3/8” Nylon Locknut (118).
Make sure that the Cable (133) is routed in the direction shown.
10.Wrap the Cable (133) around a 4” Pulley (113) and attach the Pulley and a Cable Trap (116) to the Press Frame (101) with a 3/8” x 3 3/4” Bolt (110), a 3/8” Washer (120), and a 3/8” Nylon Locknut (118).
Make sure that the Cable (133) is routed in the direction shown.
11.Slide the end of the Cable (133) between the 4” Pulley (113) and the Cable Trap (116) assembled in step one.
8 |
|
|
|
| 122 |
|
| 120 |
|
| 127 |
|
| 133 |
| 120 |
|
| 117 |
|
|
| 101 |
9 |
|
|
|
| 110 |
|
| 113 |
|
| 133 |
|
| 116 |
| 120 |
|
| 118 | 104 |
|
| |
10 |
|
|
| 101 | 110 |
|
| 113 |
|
| 116 |
|
| 133 |
118 | 120 |
|
|
| |
11 |
|
|
| 133 |
|
| 116 |
|
| 113 |
|
8