16.Wrap the High Cable (73) around a 4” Pulley (35) in the direction shown and attach the Pulley to the Top Frame (1) with a 3/8” x 2 1/2” Bolt (54), two 3/8” Flat Washers (55), two 5/8” x 1/2” Pulley Bushings (42), and a 3/8” Nylon Locknut (63).
17.Thread the 1/2” Plain Nut (68) part way onto the bolt at the end of the High Cable (73).
Place the 1 1/2” Flat Washer (40) on top of the Weight Tube (36) and the Long Bushing (76).
Tighten the bolt at the end of the High Cable (73) into the threaded hole in the Weight Tube (36).
When all Cables (73, 72 [not shown], 133 [not shown]) are tight, tighten the 1/2” Plain Nut (68) onto the 1 1/2” Flat Washer (40).
16 | 42 | 35 |
|
| 42 |
63 |
|
|
55 |
|
|
1 |
| 55 |
| 73 | 54 |
17 |
| 73 |
|
| |
|
| 68 |
|
| 40 |
|
| 76 |
|
| 36 |
Go to the Seat And Plate Assembly section on page 12 and continue with step 18.
10