Kyocera FS-3700 manual Error Messages, CallservicepersonFn123456

5.5. Indicators and Messages

MessageE	Corrective Action
	n012
	Mechanical error ( = , , , ...)—Call a service person. The printer does
CallservicepersonFn:123456	not operate when a message beginning with Eis displayed. The total number
	of pages printed is also indicated.
	n012
	Controller error ( = , , , ...)—Call a service person. The printer does
	not operate when a message beginning with Fis displayed. The al number
	of p es printed is also indicated.
Error Messages
Table 5.3 Err r Messages
MemoyoverMessageflow	Corrective Action
	The total amount of data received by the printer exceeds the printer’s internal
	memory. Try adding more memory (expansion RAM). Pre	the CONT key to
..PrintPressCONTrun	resume printing. You can abandon printing by the CANCEL key.
	The data transferr d to the printer was too complex to print on a pa e. Press
	the CONT key to resume printing. (The page may break in	ome pages.)
	You can abandon prin ing by the CANCEL key.
	Note: After this message has been displayed, Page prot ct mode w ll be
	On>Pageprotect. To maintain optimum use of memory during pri ting, display
	from the control panel, and re-sel ct Auto.
MEMORYInsertCARDagainerr	See the last page in this manual.
	The memory card is accidentally removed from the printer’s memory c rd slot
	during reading. If you continue reading the memory card, insert the s me
	memory card into the slot again. The printer again reads it from the
	beginning of the data.
	Note: We recommend that you follow the reading procedure from the
Insertthesame	beginning to ensure correct reading of the memory card.
	You have inserted the wrong memory card when the Insertagain
	message was displayed. Remove the wrong memory card from the printer’s
	memory card slot and insert the correct memory card. The printer again reads it
Fomaererror	from the beginning of the data.
	This message appears when the printer is in the ready state and the memory
	card is not formatted, and therefore cannot be read or written. Follow the
Watteryningbattery	procedure on Section 2.10. to format the card.
	This message appears when the printer is in the ready state and the battery in
	the memory card is low. You can still enter the memory card mode, but the
BMEMORYCARD	battery should be changed as soon as possible.
	This message appears when the printer is in the ready state and the battery in
	the memory card is dead, or there is no battery at all. It is not possible to use
	the memory card mode until you insert a good battery in the card.

5-9