Kyocera FS-3700 manual Message Corrective Action, Key

5.5. Indicators and Messages

Maintenance Messages

Table 5.2 Maintenance Messages

Message		Corrective Action
Top cover		Open the top cover, then close tightly.
Open
Side cover		Open the side cover, then close tightly.
Open
Paper feed unit		Open the paper feed unit, then close tightly.
Open
Face-down tray		The face-down tray has become full (approx. 250 pages). You must remove
paper full		all printed pages from the face-down tray. When the printer senses that the
		face-down tray is empty again, it will continues printing into the face-down
		tray. (Model FS-3700 only)
Add paper		Add paper to the paper cassette or multi-purpose tray.
Set paper		Add a sheet of paper to the multi-purpose tray (manual mode), and press the
Press CONT		CONT key.
Load paper		The paper size does not match. The size of the paper in the cassette is
( paper size)		different to the size specified by the application software or by PRESCRIBE II.
		Either put paper of the specified size into the cassette. See Section 1.4.
		If the CONT key is pressed, printing will be resumed. However, if more than
		one sheet is to be printed, the same message will again be displayed from the
		second sheet onward.
		You can abandon printing by pressing the CANCEL key.
Paper jam		Open the top cover or the paper feed unit and correct the paper jam (or paper
		mis-feeding in the cassette). See Section 5.6.
Warning		The printer’s internal memory is running low due to the number of fonts and
Low memory		macros downloaded. Print a status page to see how much user memory is
		left, and try deleting unnecessary fonts and macros. See the PRESCRIBE II DELF
		and DELM commands explanation in the programming manual (CD-ROM).
Toner low TK-20		Replace the toner container using a new toner kit. See Section 4.1.
Clean printer
Replace Toner		Replace the toner container using a new toner kit. The printer does not
Clean printer		operate when this message is displayed. See section 4.1.
Clean printer		Please clean the inside of the printer. See Section 4.2.
..Press CONT		This message will be displayed when replacing the toner container after the
		message Replace Toner Clean printer has been displayed.
		After cleaning the inside of the printer, press the CONT key and the printer will
		be ready for printing.
Replace	Waste-	Replace the old waste toner bottle with the new one which is included in the
toner bottle		TK-20/TK-20H toner kit. The message will also be shown if the waste toner
		bottle has become full. The waste toner bottle should be replaced when the
		message display eventually shows Toner low TK-20 Clean
		printer. See Section 4.1.
Missing	Waste-	Install the waste toner bottle. See Section 1.4. The printer does not operate
toner bottle		when this message is displayed.

5-8