Kyocera FS-3700 manual Foccupied

5.5. Indicators and Messages

MEMORYCARD..PressMessageCONTerr##				Corrective Action
	This message appears when an error occurs during access to the memory card
	using9the PRESCRIBE II ICCD command or from the printer’s control panel (codes
	1and 11only). The error is indicated by one of the numbers ##listed below.
	: Card size error (An attempt was made to write data of greater than 16
	MB in size.). Reduce the size of the data to be written from the host computer
	to216 MB or less; or, a file name could not be found in the memory card.
	3: No memory card inserted. Insert a proper memory card.
	: Non PCMCIA card. Replace the card with a PCMCIA card. This message
	appears4	when the printer attempts to identify the card.
	: Not RAM card. Use a SRAM-type card if you want to write data to an
	memory5	card.
	: Memory card battery error. Replace the memory card’s internal battery
	with6a new one.
	: Memory card protect error. Release the write protection on the memory
	card7when you write data to the memory card.
	: Non-Kyocera format. Reformat the memory card using MODE SELECT
	(See8page 2-21.).
	: Partition name error. Follow instructions given attempt in Chapter 2 to
	0properly9		ame the destination.
	: Memory card data full error (An attempt was made to write data
	exceeding the capacity of the memory c r ). Abandon the writing operation
	onWaitingthe host computer first. Press CONTkey; when the message turns to
	1			, press FORMFEEDkey (Ready).
	: Data name full (An attempt was made to write more than 127
	destination3			data names). Press CONTkey (Ready).
	5: Erase logic error with flash memory card. Try replacing the memory card.*
	: Non PCMCIA flash card. Replace the card with a PCMCIA flash card.*
	This message appears when the printer attempts manipulating data on a
	flash7card.
	: Unable to write to the flash memory card due to insufficient printer
	memory. Either delete unnecessary macros or fonts stored in the printer, or
	extend18the printer’s available memory.*
	: Writing error. Try replacing the memory card.*
>ReadFailedfonts	* : Flash card only.
	The amount of memory available for the fonts header parts of font is too
I/Foccupied	small to load more fonts. Try deleting unnecessary fonts and macros.
	This message is displayed when you attempt to use the printer’s control panel
	to change the environmental settings on the interface from which data are
PARrocessingFITA4	presentlyFIT		being received.
	(image FITting) flashes to indicate that a loss of raster data occurred
	when the data was compressed to be fitted within the currently available
	memory. Flashing FITextinguishes automatically when the job times out;
	the printer receives the next data from the host computer; or if you press any
	key on the printer’s control panel. Try adding more memory in the printer to
PAR300ARrocessing600A4A4	prevent this error.
	Change of the resolution indicator from 600to 300(flashing) means that
	the job in 600-dpi resolution was not able to run within the currently available
	memory. The resolution reverts to 600dpi automatically when the job times out;
	the printer receives the next data from the host computer; or if you press any key
	on the printer’s control panel. Try adding more memory in the printer to prevent
	this error.

5-10