NordicTrack NTM58020 Wires, Be careful to avoid, Pinching the wires, During this step

5.While another person holds the Left Handlebar (6) near the Upright (3), Connect the Handgrip Pulse Wire (70) to the Pulse Extension Wire (98). Insert the excess wiring into the Left Handlebar.

Hold two Handlebar Bushings (66) around the rectan- gular tube on the left side of the Upright (3). Slide the Left Handlebar (6) onto the Handlebar Bushings and the tube on the Upright; be careful not to damage the the Handgrip Pulse Wire (70) or the Pulse Extension Wire (98). Attach the Left Handlebar with two M8 x 35mm Button Bolts (24), two M8 Split Washers (54), and two M8 Nylon Locknuts (28); be careful not to damage the Wires as you insert the Button Bolts. Firmly tighten the Nylon Locknuts.

Attach the Right Handlebar (5) in the same way.

6.While another person holds the Console (4) near the Upright (3), connect Extension Wire Harness (77), the Pulse Extension Wire (98), and the ground wires to the corresponding wires on the Console. Insert any slack wire up into the Console and down into the Upright.

Attach the Console (4) to the Upright (3) with four Console Screws (57). Make sure that the wires are not pinched.

Snap the bookrack onto the Console (4) in the location shown.

5
			5
	66
28	70		3
			Be careful
		98
			to avoid
6			pinching the
	54	24	Wires (70,
			98) during
			this step.
6	4
			Bookrack
	77
	98
			Console
			Wires
			Ground
			Wires
		3
57			Be careful to avoid
			pinching the wires
			during this step.

7.Make sure that all parts of the stepper are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the stepper.

6