13.Feed the bolt on the High Cable (73) through the indi- cated slot in the Main Upright (3) in the direction shown. The Cable should wrap around the Pulley that was attached in step 11.
Wrap the High Cable around a 4Ó Pulley (35). The Cable must wrap around the Pulley in the direction shown.
Attach the 4Ó Pulley (35) to the Right and Left Press Arms (46, 82) with the 3/8Ó x 8 1/2Ó Bolt (59) and the 3/8Ó Nylon Locknut (50).
14.Feed the bolt on the High Cable (73) back through the slot in the Main Upright (3) in the direction shown.
Wrap the High Cable (73) around a 4Ó Pulley (35). Attach the Pulley to the Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42), and a 3/8Ó Nylon Jamnut (63).
15.
Wrap the High Cable (73) around a 4Ó Pulley (35). Attach the Pulley to the upper end of the Pulley Plates (31) with a 3/8Ó x 1 3/4Ó Bolt (60), a Cable Trap (44), and a 3/8Ó Nylon Jamnut (63). Make sure the
Cable is in the groove of the Pulley and that the Cable Trap is oriented as shown, so it will hold the Cable in place.
Put the remaining Pulley, Cable Trap, Jamnut and Bolt aside. They will be used in step 19.
13 | 73 | 3 |
| ||
|
| |
Slot |
|
|
|
| 59 |
|
| 35 |
50 |
| Bolt |
|
| 82 |
|
| 46 |
14 |
|
|
|
| 55 |
|
| 42 |
|
| 54 |
73 | 35 |
|
|
| |
63 |
|
|
| 42 |
|
| 55 |
|
|
| 3 |
15 |
|
|
|
| 60 |
35 | 44 | 31 |
31 |
|
|
|
| 73 |
63 |
| Adjustment |
| Holes | |
|
|
10